Installation and maintenance of cone crusher
The maintenance of the machine is an extremely important regular work, which should be closely coordinated with the operation and overhaul of the machine, and full-time personnel should be on duty for inspection.
Maintenance of the machine
1. Bearings
The shaft of the crusher bears the full load of the negative machine, so good lubrication has a great relationship with bearing life, which directly affects the machine
The service life and operating rate, so the lubricating oil injected must be clean, the seal must be good, the main oil injection place of this machine
(1) Rotating bearings (2) Roll bearings (3) All gears (4) Movable bearings, sliding plane
2. The newly installed wheel hoop is prone to loosening and must be checked frequently;
3. Pay attention to whether the work of each part of the machine is normal;
4. Pay attention to check the wear degree of wearable parts, and pay attention to replacing the worn parts at any time;
5. Put the bottom frame plane of the movable device, dust and other objects should be taken out to prevent the movable bearing from moving on the base frame when the machine encounters materials that cannot be broken, resulting in serious accidents;
6. If the bearing oil temperature rises, the reason should be eliminated immediately for stop and check;
7. If there is an impact sound when the rotating gear is running, it should be stopped immediately for inspection and eliminated.
Installation and commissioning
1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts;
2. When installing, pay attention to the vertical of the main body and the horizontal;
3. After installation, check whether the bolts of each part are loose and whether the main engine compartment door is tightened, if so, please tighten it;
4. Configure the power cable and control switch according to the power of the equipment;
5. After the inspection, the no-load test run will be carried out, and the test run can be produced normally.
